Clearing the Decoupler

1. Remove the S5 from the Material Station; be sure to unplug the black power cable and white UMB Cable.

2.  Remove the two screws securing the top foam in place.

3. Unclip the Decoupler from the inside of the machine.

4. Unplug the decoupler cable. You should be able to clear the decoupler by shaking material out, though you may need to use a piece of filament or screwdriver to fully remove material. While the decoupler is off is a good time to check for broken material as it's much easier to pass a cut off section of filament through the different paths connected to the removed decoupler.